AMX Modero NXT-1500VG, Operation/Reference Manual

Page: 51 / 252

Touch Panel Accessories
41 VG-Series Modero Touch Panels
4. Remove the new CF memory card from it’s anti-static bag.
5.
Grip the sides of the new CF memory card and firmly insert it into the slot opening (with the arrow
facing towards the pins) until the contact pins are completely inside the flash card and it is then
securely attached to the pin sockets.
6.
To complete the upgrade process, close and resecure the panel enclosure using the procedures in the
following step.
Step 5: Close and Resecure the NXT Panel Enclosure
1.
Obtain the new RGB I/O connector plate (similar to the original but containing the added RGB
connector opening to the newly installed NXA-RGB) and slide it back into position.
2.
Resecure the Stereo Output nut back onto the new Stereo Output jack onto the new RGB I/O plate.
3.
With the components securely installed, tilt the LCD back to a 45° and then gently slide-on the outer
housing (towards the LCD) until the it is aligned over the installation holes and the tilt bracket
prevents any further forward movement (FIG. 19).
4. Gently press down on the housing (toward the base) until it is securely positioned over the circuit
board and cover base.
5.
While holding the circuit board cover in place, turn the panel back over until the LCD lies facedown
on a soft cloth and the under-side of the base is exposed.
6. Insert and secure the eight Housing Screws (using a grounded Phillips-head screwdriver) into their
respective locations (FIG. 15).
7.
Replace any adhesive plastic "feet" that might have been removed during the removal process of the
outer housing.
These "feet" must be placed back onto their original locations so they can fit into
their provided openings on the Battery Base.
FIG. 21 Removing/installing a Compact Flash Memory card
Card removal
grooves
Insert with arrow
facing towards the pins
On-board Compact
Flash connector (with pins)
Connector opening
Any new internal component upgrade is detected by the panel only after power is
cycled.
Use caution when re-installing the outer housing. Improper re-installation can cause
damage to the internal speakers.