Ametek Thermox CEM O2/TM, User Manual

Page: 94 / 168

5-4 | Thermox CEM O2/TM
• Define how long calibration gases should be applied to the sensor dur -
ing an auto calibration or verification (Set Cal Timers/Cal Gas Dura-
tion).
• Define recovery duration times (Set Cal Timers/Recovery Duration).
• Define verify gas values to match known values of verify gas cylin -
ders; enter acceptable verify range (Configure Verify).
Aborting a Calibration
If you press the Calibrate key while the system is performing a calibra-
tion, you will be have the option to either abort or to continue the calibra-
tion. All other menu functions are temporarily disabled during a calibra-
tion
Password
System passwords are created using the Setup key. Please see the
“Password” section in the Setup Key section of the Controller/User
Interface chapter for information on defining or disabling a system
password.
If a system password is enabled, you will be required to correctly enter
this password before accessing certain Calibrate key functions.
Entering a Password
When you select certain Calibrate key menu options that have password
restrictions, you will be prompted to enter your system password (assum-
ing a password has been defined):
Enter Password
Enter the four digit system password. To protect the identification of the
password, the numbers you enter will not be displayed.
You will then be allowed to access Calibrate key functions.
NOTE
