Amada HF-2500A, Operation Manual, Page: 66 / 164

CHAPTER 5. OPERATING INSTRUCTIONS
HF-2500A HIGH FREQUENCY WELD CONTROL
5-2 990-371
Initial Setup
1. Adjust the weld head force adjustment knob for a force appropriate for your welding application.
A good starting point is the mid-point in the range of the weld head force.
2. Set the
WELD/NO WELD
switch on the Power Supply front panel to the
NO WELD
position. In
this position, the Power Supply will operate the weld head without producing weld energy.
NOTE: When you are ready to perform a weld, be sure to set this switch back to the
WELD
position.
3. Turn the
ON/OFF
switch on the rear panel of the Power Supply to the
ON
position. The default
RUN
screen will be displayed. You will use this screen to enter welding parameters.
Default RUN Screen