Amada HF-2500A, Operation Manual, Page: 142 / 164

APPENDIX E. COMMUNICATIONS
HF-2500A HIGH FREQUENCY WELD CONTROL
E-20 990-371
weld_energy is the parameter that specifies the amount of weld energy.
•
Current Feedback mode: the weld_energy range for the HF-2500A is from 10 to 2.400
A (10 to 2400).
•
Voltage Feedback mode: weld_energy for the HF-2500A is in units of 0.001 V, and the
range is from 0.200 to 9.9V (200 to 9900). (Note: Maximum attainable voltage is
dependent on the HF-2500A model and the load resistance).
•
Power Feedback mode: weld_energy for the HF-2500A is in units of 1 W, and the range
is from 10 W to 9900 W (10 to 9900).
volt multiplier is the index value for a table of resistance vs. a PID multiplier for voltage mode
(used for the last weld). Note: Not used in versions where RINDEXx and EINDEXx are
present.
resistance index is the index value into a table of resistance vs. energy PID tables used for the
last weld.
energy index is the index value into a PID energy vs. PID values table used for the last weld.
Command
MONITOR schedule_number <crlf>
MONTYPE1 { KA | V | KW | R } <crlf>
UPPER1 { limit_value } <crlf>
LOWER1 { limit_value } <crlf>
ACTION1 { none | STOP | INHIBIT | APC } <crlf>
MONTYPE2 { KA | V | KW | R } <crlf>
UPPER2 { limit_value } <crlf>
LOWER2 { limit_value } <crlf>
ACTION2 { none | STOP } <crlf>
P1LDLY1 { delay_value }<crlf>
P1LDLY2 { delay_value }<crlf>
P1UDLY1 { delay_value }<crlf>
P1UDLY2 { delay_value }<crlf>
P2LDLY1 { delay_value }<crlf>
P2LDLY2 { delay_value }<crlf>
P2UDLY1 { delay_value }<crlf>
P2UDLY2 { delay_value }<crlf>
<lf>
Control State Any
Description Reports the settings of the weld monitor of the currently loaded Power Supply schedule. The
schedule_number variable identifies which schedule is currently loaded, and may be any value
from 0 to 99. The possible value for all variables listed after their parameter name correspond
to the values listed under
MONITOR in Host Originated Commands of this manual.