Amada HF-2500A, Operation Manual, Page: 103 / 164

APPENDIX B: ELECTRICAL AND DATA CONNECTIONS
HF-2500A HIGH FREQUENCY WELD CONTROL
990-371 B-3
10-Pin Connectors
Three un-wired, “blank” 10-pin connectors are supplied in the Ship Kit. These connectors are used for
the configurations described in
Section III, I/O Configuration. These connectors easily snap apart and use
screw-terminal wire connections so no soldering is required. Each pin of this connector has a tab on top
as shown below.
When you fabricate I/O cables according to the configuration instructions,
you must also cut off the tabs
on the top of specific pins as indicated by the black shading below .
Example: To fabricate a connector for pins
31 - 40
, you must remove the tabs for pins
34
,
35
, and
36
. If
you do not remove the appropriate tabs, you will not be able to insert the plug into the Power Supply.