Amada HF-2500A, Operation Manual, Page: 138 / 164

APPENDIX E. COMMUNICATIONS
HF-2500A HIGH FREQUENCY WELD CONTROL
E-16 990-371
WELD STATUS CODES
Number Status Message
0 GOOD
1 CHECK CONTROL SIGNALS INPUT STATUS
2
CHECK INPUT SWITCH STATUS
3 FIRING SWITCH BEFORE FOOT SWITCH
4 STOP ON CONTROL SIGNALS INPUT
5
POWER TRANSISTOR OVERHEATED
6
EMERGENCY STOP - OPERATOR ACTIVATED
7 FIRING SWITCH DIDN'T CLOSE IN 10 SECOND
8 WELD TRANSFORMER OVERHEATED
9 TEST WELD
10
VOLTAGE SELECTION PLUG IS MISSING
11 INHIBIT CONTROL SIGNALS ACTIVATED
12 LOW BATTERY
13 NO CURRENT READING
14
NO VOLTAGE READING
15 LOAD RESISTANCE TOO HIGH
16 NO WELD TRANSFORMER DETECTED
17
WELD SWITCH IN NO WELD POSITION
18
CHECK VOLTAGE CABLE & SECONDARY CIRCUIT
19 CALIBRATION RESET TO DEFAULT
20 LOWER LIMIT GREATER THAN UPPER LIMIT
21 COOL TIME ADDED FOR DIFFERENT FEEDBACK
22
ENERGY SETTING TOO SMALL
23 SYSTEM & SCHEDULE RESET TO DEFAULTS
24 LIMITS ROUND UP
25 CHAINED TO NEXT SCHEDULE
26
SAFE ENERGY LIMIT REACHED
27 P1 LOWER LIMIT DELAYS ADJUSTED
28 P1 UPPER LIMIT DELAYS ADJUSTED
29
P2 LOWER LIMIT DELAYS ADJUSTED
30
P2 UPPER LIMIT DELAYS ADJUSTED
31 UPSLOPE REQUIRED FOR LOWER LIMIT