Airoptic GasEye, User Manual

Page: 87 / 254

Electrical installation
GasEye Cross Duct
Operating instructions, 05/2021
87
5 - Lasers temperature stabilization
(lasers are off)
6 - Lasers temperature stabilization
(lasers are on)
7 - Lasers transmission check
8 - Self-calibration procedure
9 - Concentration measurement
check
10 - Normal operation of the device
(startup procedure is finished)
SYSTEM.TRANS_MP1_STATUS 0x4C 76
Value 1 ok
Value 0 warning
SYSTEM.ERR_CODE 0x4D 77 Reserved - future use
SYSTEM.AIO_ERROR 0x4E 78 Reserved - future use
SYSTEM.DIO_ERROR 0x4F 79 Reserved - future use
SYSTEM.RTD_PRESS_ERROR 0x50 80 Reserved - future use
SYSTEM.ALARM1 0x51 81 Alarm 1
SYSTEM.ALARM2 0x52 82 Alarm 2
SYSTEM.ALARM3 0x53 83 Alarm 3
SYSTEM.ALARM4 0x54 84 Alarm 4
SYSTEM.ALARM5 0x55 85 Alarm 5
SYSTEM.ALARM6 0x56 86 Alarm 6
SYSTEM.ALARM7 0x57 87 Alarm 7
SYSTEM.ALARM8 0x58 88 Alarm 8
SYSTEM.ALARM9 0x59 89 Alarm 9
SYSTEM.ALARM10 0x5A 90 Alarm 10
SYSTEM.CALIB_MODE 0x5B 91 Run in system calibrated mode
AOUT1
0x5C 92
16 -bits of floating point value (first
part)
Analog output value
0x5D 93
16 -bits of floating point value
(second part)
Analog output value
AOUT2
0x5E 94
16 -bits of floating point value (first
part)
Analog output value
0x5F 95
16 -bits of floating point value
(second part)
Analog output value
AOUT3
0x60 96
16 -bits of floating point value (first
part)
Analog output value
0x61 97
16 -bits of floating point value
(second part)
Analog output value