存放
Storage
6.4
液压悬挂系统调整
Hydraulic hitch system adjustment
6.4.1
提升器的调整
Adjustment of hydraulic hitch system
前驱动桥最终传动的调整见图。
Final drive system adjustment of front axle refers
to the figure.
前驱动桥最终传动的
2
个圆锥滚子轴承
7
是预紧
的。检查调整时先拆下螺栓
1
,取下行星架
2
,
将调节螺母
3
拧紧,然后再退回
l
/
10
~
l
/
6
圈,
使前轮毂
6
转动灵活,最后将拆下的零件重新装
配拧紧。
Two tapered roller bearings 7 of final drive system
of front axie are pretightened. When checking and
adjusting, remove planet carrier 2 and tighter
adjusting nut 3, then back 1/ 10 - 1 / 6 circle to
图
6-16
最终传动的调整
make front hub 6 rotate flexibly, and finally
Fig. 6-16 Final drive system adjustment of front axie
re-assembles and tightens all removed parts.
1.
螺栓
2.
行星架
3.
调节螺母
4.
驱动轴
5.
太阳轮
6.
前轮毂
7.
圆锥滚子轴
1.bolts; 2.planet carrier; 3.adjusting nut;
4.driving shaft; 5.sun gear; 6.front hub;
7.taper roller bearing