244
S:\agilent\e8285\USRGUIDE\BOOK\CHAPTERS\memcard.fb
Chapter 5, Memory Cards/Mass Storage
Default Mass Storage Locations
Default Mass Storage Locations
Built-in IBASIC Controller
The default mass storage location for the built-in IBASIC Controller is the front-
panel memory card slot (mass storage volume specifier ":INTERNAL,4") after
any of the following conditions:
•
power-up
•
initializing RAM with the SERVICE screen’s
RAM Initialize
function
The mass storage location for the built-in IBASIC Controller can be changed
using the MASS STORAGE IS command. Refer to the HP
®
Instrument BASIC
Users Handbook for further information on the MASS STORAGE IS command.
Save/Recall Registers
The default mass storage location for the Save/Recall registers is the Test Set’s
internal RAM (no mass storage volume specifier) after any of the following
conditions:
•
Power-up
•
Initializing RAM with the SERVICE screen’s
RAM Initialize
function
•
Resetting the Test Set using the front-panel Preset key
•
Resetting the Test Set using the *RST GPIB Common Command
The mass storage location for Save/Recall registers can be changed using the
Save/Recall
field in the I/O CONFIGURE screen. The default mass storage
volume specifiers for the Save/Recall register mass storage locations are as
follows:
•
Internal selection - (no mass storage volume specifier, registers are saved to allocated
RAM space)
•
Card selection (not changeable) - ":INTERNAL,4"
•
RAM selection (not changeable) - ":MEMORY,0,0"
•
Disk selection - the
External Disk Specification
field in the TESTS
(External Devices) screen.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com