Aerotech UNIDEX 600 Series, User Manual

Page: 25 / 354

Preface U600 User’s Guide
xxiv
Aerotech, Inc.
Version 1.4
CHAPTER 9: AERPLOT3D
This chapter contains information about AerPlot3D. This utility program allows for
continuous plotting of three axes of motion during a CNC program.
CHAPTER 10: AERPLOTIO
This chapter contains information about AerPlotIO. This untility program plots I/O and
Registers vs. Time.
CHAPTER 11: FILTER
This chapter contains information about the Filter utility. This program calculates values
for the second order of digital filter.
CHAPTER 12: SETUP WIZ
This chapter contains information about the Setup Wiz utility. This program allows you to
configure your controller with English text prompts for required parameters.
CHAPTER 13: PRMSETUP
This chapter contains information about the PrmSetup utility. This program will install the
pre-configured .Ini files onto your PC.
APPENDIX A: GLOSSARY OF TERMS
Appendix A contains a list of definitions of terms used in this manual.
APPENDIX B: TROUBLESHOOTING
Appendix B contains information on troubleshooting the most common problems when
using the UNIDEX 600 Series motion controllers.
APPENDIX C: PARAMETERS
Appendix C contains all the available parameters used by the UNIDEX 600 Series
controllers.
APPENDIX D: WARRANTY AND FIELD SERVICE
Appendix D contains the warranty and field service policy for Aerotech products.
INDEX
The index contains a page number reference of topics discussed in this manual. Locator
page references in the index contain the chapter number (or appendix letter) followed by
the page number of the reference.
CUSTOMER SURVEY FORM
A customer survey form is included at the end of this manual for the reader’s comments
and suggestions about this manual. Reader’s are encouraged to critique the manual and
offer their feedback by completing the form and either mailing or faxing it to Aerotech.