Adtech 4 Series, Maintenance Manual

Page: 76 / 155

ADTECH 4 series CNC System (maintainance Manual)
72
Effective time : Instant
Note :
Used to set whether G00 instruction is work as G01
If this setting is 1 ,that means when the controller excute G00,it will work
as G01(interpolation,not fast move )
If G01 is used, the interpolation speed shall follow the setting of
minimum speed;
The acceleration is the interpolation acceleration.
Range : off/ pos mem/ sta mem
Unit :
Authority : Operation admin or higher
Default : off
Effective time : Instant
Note :
used for the controller abnormal stop at the process of working ,power off
or other abnormal stops
if The setting is pos mem ,the system will memory the current
position ,then reboot or press start ,system show message and after
starting ,it will move to the last position,press start again ,it work
if The setting is sta mem, ,the system will memory the current state, ,then
reboot or press start,the system will work directly from the last position
Range : off/ Abs coord/ Mac coord
Unit :
Authority : Operation admin or higher
Default : off
Effective time : Instant
Note : 0 is diaable
when the controller pause (during working),the A and Z axis will move to
the P1.050 and P1.049 setting safty position (this coordinate can be
workpiece coordinate or machine coordinate)
Range : off/ Abs coord/ Mac coord
Unit :
Authority : Operation admin or higher
Default : off
Effective time : Instant
Note : 0 is diaable
1 is enable ,When the controller go home (machine home or program
home ) at home mode ,the working process is that move to X---C coord
offset setting coordinate (coord ---- set)
Range : Mac coord / G54 coord
Unit : None
Home mode cls coord 048
Pro RZ to reference pos
Mac RZ to reference pos
046
047
Z rise to safe pos en
Arise to safe pos en
044
045
Abnormal memory En
043