Adtech 4 Series, Maintenance Manual

Page: 32 / 155

ADTECH 4 series CNC System (maintainance Manual)
28
8. Program saving & editing
8.1 Saving the program to the memory
8.1.1 Keypad input (new program)
Create new program in the memory with the keypad, and the step as follows:
➢
In the main menu, press [Edit] to enter program edit interface;
➢
Press [File]
➢
Select [New] to create a new file;
➢
Enter the file name and press [EOB] to confirm and create a new program in current directory in the
memory, and load into the controller by default ;
➢
Select [Close] to exit [Edit] interface;
➢
In edit mode, enter the program content;
➢
After editing all programs, press [Reset] to save the edited programs into the system memory.
8.1.2 PC serial port input
The step of loading files to controller through PC follows:
➢
Set system baud rate and ID No.;
➢
Connect to PC and run Adtech serial communication software;
➢
Set the baud rate same as controller, and scan ID device;
➢
Select the [Upload file to NC] button in the communication software;
➢
Select CNC file in the popup dialog box and press [Open] button.
8.1.3 Copy program from USB disk
The step of copying CNC file to system memory through USB disk as follows:
➢
Press [File],find [data traveler]
➢
Select [data traveler] and press [EOB] to enter;
➢
Move the cursor to select a CNC file and then select [Copy];
➢
Press [File] again,select [local disk(d)],and press [EOB]
➢
Select [PROG] folder,press[EOB] to enter ,then press [paste]to complete copying.