Adtech 4 Series, Maintenance Manual

Page: 73 / 155

ADTECH 4 series CNC System (maintainance Manual)
69
028 PretreatmentCode Set
Range :
Unit : Coefficient
Authority : Operation admin or higher
Default : 50, 100
Effective time : Instant
Note :
Used to restrict the arc processing speed automatically. This parameter is
valid in pretreatment mode.
The bigger the radius coefficient is, the lower the arc speed is.
The bigger the acceleration coefficient is, the higher the arc speed is.
Range : 100~3000
Unit : Instruction line
Authority : Operation admin or higher
Default : 500
Effective time : Instant
Note :
Set the pre-reading instruction lines; if the pretreatment processing
pauses and pre-reads, please increase this value to pre-read more
instructions.
Range :
Unit :
Authority : Operation admin or higher
Default :
Effective time : Instant
Note :
Inp AccSpeed Mode: it for setting the interpolation acceleration/
deceleration, 0 is linear acceleration and deceleration ; 1 is S curve
acceleration/deceleration
'S'Speed Acceleration: Used to set the performance of S curve
acceleration/deceleration
Range : 0~1
Unit :
Authority : Operation admin or higher
Default : 0, 1
Effective time : Instant
Note
: HOME Check for alarm :if there is alarm in controller ,and after the
alarm removed ,the controller need go home point or not before working.
0 : disable ,no need go home point before working
1: enable ,need go home before working.
HOME Check Enable :after power on ,the controller whether go home
point or not
HOME Check for alarm
HOME Check Enable
031
032
Inp AccSpeed Mode
'S'Speed Acceleration
029
030
Arc Acc.for Speed 027