Adtech 4 Series, Maintenance Manual

Page: 48 / 155

ADTECH 4 series CNC System (maintainance Manual)
44
[DGNOS]
Alert
Input
Output
module
Sys Info
➢
Z negative limit is used to prevent crash caused by not in right place of Z axis. Once negative limit
alarm occurs, the tool setting gauge stops working immediately. If the system is in working state, the
system will send alarm; during separate setting of the tool setting gauge, the alarm won‘t occur.
9.9 Controller diagnosis interface (DGNOS)
The diagnosis interface is used to display the hardware interfaces and system info, including alarm, input,
output, DA diagnosis; press [DGNOS] to enter the diagnosis interface.
The diagnosis interface as follows:
Alert interface
Display the alarm of the system after power on, including 15 alarm records.
IO diagnosis interface
IO diagnosis allows entering at any moment. You can check current IO state of the controller. In Jogmode,
press the direction keys to select corresponding IO, and press EOB to control the output manually.
DA diagnosis interface(module)
Correct the output voltage of two lines DA voltage module for testing; press the ―
→
‖, ―
←
‖, ―
↑
‖,―
↓
‖to
output corresponding voltage directly, input the actually measured voltage to corresponding position; when call
instructions of spindle, the system will correct according to correction value.
System info
The system info shows basic information of current system, and is used to mark current software version,
hardware version, upgrade info, etc. In this interface, you can follow the prompt to perform operations.
9.10 Macro variable view interface (macro variable)
This is the variable register view menu of macro function. In this menu, you can turn pages to view the
macro variables, or enter values to variable register directly in edit mode.