Adtech 4 Series, Maintenance Manual

Page: 82 / 155

ADTECH 4 series CNC System (maintainance Manual)
78
XBacklashExpiate(pulse)
YBacklashExpiate(pulse)
ZBacklashExpiate(pulse)
4BacklashExpiate(pulse)
BBacklashExpiate(pulse)
CBacklashExpiate(pulse)
X HOME Offset(mm)
Y HOME Offset(mm)
Z HOME Offset(mm)
4 HOME Offset(mm)
B HOME Offset(mm)
C HOME Offset(mm)
Unit : mm
Authority : Operation admin or higher
Default : 9999 / -9999
Effective time : Instant
Note : Usually , the machine has hardware limit signal. In this case, software
limit isn‘t required. Then Please set the positive limit to +9999.999, and
negative limit to -9999.999.
If hardware limit switch isn‘t installed, please use soft limit, which uses
machine home point as reference point. Positive limit and negative limit
are subject to actual distance (unit: mm).
Since soft limit decelerates and stops at the limit point, it may exceed the
seting distance, which depends on acceleration time and speed. Please
keep certain margin when setting this parameter.
Range : 1---20000
Unit : pulse
Authority : Operation admin or higher
Default : 0
Effective time : Instant
Note : Compensate the backlash of ballscrew or Pulley
Compensate with the pulse in minimum unit(the pulse equivalent). For
example :if the forward is 100mm,but backward is 98mm ,that means the
backlash is 2mm,if the the pulse equivalent is 0.001 ,then compensation
pulse is 2/0.001=2000
Range : -9999
～
9999
Unit : pulse
006
007