Adtech 4 Series, Maintenance Manual

Page: 69 / 155

ADTECH 4 series CNC System (maintainance Manual)
65
Range : No use ,Network,Uart,All User
Unit : None
Authority : Operation admin or super
Default : 0
Effective time : reboot
Note :
Select communication mode ,there are four selection for communication
with pc ,no use : don‘t allow communicate with pc ; Network :controller
communicate with pc via network; uart : controller communicate with pc
via RS232; All User :support network and uart communication mode.
Range : 1~10000
Unit : mm/min
Authority : Operation admin or super
Default : 9000
Effective time : Instant
Note :
This parameter for setting MPG Maximum speed ,the max setting is
10000, if this setting value is too low ,the MPG will not work
well .uauslly ,the default value is ok
Range : 1~3000
Unit :
Authority : Operation admin or super
Default : 1000
Effective time : Instant
Note :
This setting is handwheel response speed . if this setting value is too
low ,the handwheel will not work well .uauslly ,the default value is ok
Range : 1~9999
Unit : ms
Authority : Operation admin or higher
Default : 100
Effective time : Instant
Note :
Set the waiting time (unit: ms) after executing M code, uauslly ,the
default value is ok
Range : 0~100
Unit : None
Authority : Operation admin or higher
Default : 0
Effective time : Instant
Wheel Coefficient
009
MaxMPGSpeed(mm/min)
008
Communication options 006
010
M Code Delaytime(ms)
011 Line number