Adtech 4 Series, Maintenance Manual

Page: 72 / 155

ADTECH 4 series CNC System (maintainance Manual)
68
022
023
024
OilPressure Open(min)
OilPressure Keep(sec)
OilPressureOut Freq(Hz)
Range : 0~1
Unit : None
Authority : Operation admin or higher
Default : 0
Effective time : Instant
Note :
This setting is corresponding to spindle S value (VFD)
0: Analog output
1: Section speed regulation (4-digit code), as below:
P4.014 ----- S0
P4.015 ----- S1
P4.016 ----- S2
P4.017 ----- S3
In analog output mode, the analog voltage is:
V=S/MaxRPM
S is the rotation set by the user, and MaxRPM is the maximum rotation
of spindle axis set by the parameter (P5.021);
In switching mode, 0-15 according to four-digit code to output; S value
is restricted to 0-15;
Range :
Unit :
Authority : Operation admin or higher
Default : 0
Effective time : Instant
Note :
OilPressure Open(min): Set the timing start and hold time of the
automatic oil pump automatic timing star setting is that after comntroller
power on ,it starts timer and when the timer over ,the oil pump
output( P6.045 setting ) is active .
The output holding time is set by 023 ,after this time over ,the output is
inactive
OilPressureOut Freq(Hz): Output signal follows the hertz specified by
024 in working processing , and used for oil supply devices. If this
setting is 0, the controller will keep low output level.
Range :
Unit : None
Authority : Operation admin or higher
Default : Z-XYABC
Effective time : Instant
Note :
This setting is sequence of machimne going home point .there are three
setting dialogs.(X—C fisrt zero, X—C second zero, X—C thirdt
zero,page dwon and page up for shift dialog),the default setting is
Z-XYABC,that mean z aixs go home firtstly(the z axis fisrt zero is set
with black point) ,then XYABC go home point together(X Y A B C
second zero settings are black point)
Arc Acc.for Radii 026
BackHome ModeConf(bit)
025
SpindleControlMode
021