Adtech 4 Series, Maintenance Manual

Page: 99 / 155

ADTECH 4 series CNC System (maintainance Manual)
95
sys display axis setting
sys debug information En
axis control composite
Default : 1s
Effective time : reboot
Note : Set the logo display mode ,if the setting is 0 ,then it should press any
button to enter the system ,if the setting is not 0 ,that means it will delay
the setting time ro enter the system .
Range :
Unit : none
Authority : Operation admin or higher
Default : XYZ
Effective time : instant
Note : Used to configure the display axis of current system, and different display
combinations are available.
This configuration only show the content of the interface. If the axis
function of the hardware exists, it still can output axis control during
programming, but the axis status won‘t be displayed. The status such as
axis limit and alarm will be ignored.
Range : 0
～
1
Unit : none
Authority : Super user
Default : Off / 0
Effective time : Instantt
Note : Used to configure whether RS232 of current system outputs the testing
info while program is running.
This parameter is dedicated for programmers, and the users are not
suggested using this parameter.
If the testing info is enabled, the system performance will be lowered,
and therefore it is disabled during normal processing.
If networking is enabled, this function must be disabled, or else the
networking will fail.
Range : 0
～
1
Unit : none
Authority : Super user
Default : on / 1
019
020
021