ABB ACS850 series, Firmware Manual

Page: 191 / 260

Parameters 191
64.24 AL2 0 to 10% Percentage of samples recorded by amplitude logger 2 that
fall between 0 and 10%.
0.00 … 100.00% Amplitude logger 2 samples between 0 and 10%. 100 = 1%
64.25 AL2 10 to 20% Percentage of samples recorded by amplitude logger 2 that
fall between 10 and 20%.
0.00 … 100.00% Amplitude logger 2 samples between 10 and 20%. 100 = 1%
64.26 AL2 20 to 30% Percentage of samples recorded by amplitude logger 2 that
fall between 20 and 30%.
0.00 … 100.00% Amplitude logger 2 samples between 20 and 30%. 100 = 1%
64.27 AL2 30 to 40% Percentage of samples recorded by amplitude logger 2 that
fall between 30 and 40%.
0.00 … 100.00% Amplitude logger 2 samples between 30 and 40%. 100 = 1%
64.28 AL2 40 to 50% Percentage of samples recorded by amplitude logger 2 that
fall between 40 and 50%.
0.00 … 100.00% Amplitude logger 2 samples between 40 and 50%. 100 = 1%
64.29 AL2 50 to 60% Percentage of samples recorded by amplitude logger 2 that
fall between 50 and 60%.
0.00 … 100.00% Amplitude logger 2 samples between 50 and 60%. 100 = 1%
64.30 AL2 60 to 70% Percentage of samples recorded by amplitude logger 2 that
fall between 60 and 70%.
0.00 … 100.00% Amplitude logger 2 samples between 60 and 70%. 100 = 1%
64.31 AL2 70 to 80% Percentage of samples recorded by amplitude logger 2 that
fall between 70 and 80%.
0.00 … 100.00% Amplitude logger 2 samples between 70 and 80%. 100 = 1%
64.32 AL2 80 to 90% Percentage of samples recorded by amplitude logger 2 that
fall between 80 and 90%.
0.00 … 100.00% Amplitude logger 2 samples between 80 and 90%. 100 = 1%
64.33 AL2 over 90% Percentage of samples recorded by amplitude logger 2 that
exceed 90%.
0.00 … 100.00% Amplitude logger 2 samples over 90%. 100 = 1%
90
90 Enc module sel
Activation of encoder/resolver interfaces. See also section
Encoder support on page 31 .
90.01 Encoder 1 sel Activates the communication to optional encoder/resolver
interface 1.
Note: It is recommended that encoder interface 1 is used
whenever possible since the data received through that
interface is fresher than the data received through interface 2.
On the other hand, when position values used in emulation
are determined by the drive software, the use of encoder
interface 2 is recommended as the values are transmitted
earlier through interface 2 than through interface 1.
None Inactive. 0
FEN-01 TTL+ Communication active. Module type: FEN-01 TTL Encoder
interface. Input: TTL encoder input with commutation support
(X32). 1
FEN-01 TTL Communication active. Module type: FEN-01 TTL Encoder
Interface. Input: TTL encoder input (X31). 2
No. Name/Value Description FbEq