85
Actual signals and parameters
Actual signals
No.
Name/Value
Description
0142 REVOLUTION CNTR
Motor revolution counter (millions of revolutions). The counter can be reset by pressing
the UP and DOWN keys simultaneously when the control panel is in the Parameter
mode.
0143 DRIVE ON TIME HI
Drive control board power-on time in days. Counter cannot be reset.
0144 DRIVE ON TIME LO
Drive control board power-on time in 2 second ticks (30 ticks = 60 seconds). Counter
cannot be reset.
0160 DI 1-5 STATUS
Status of digital inputs. Example: 10000 = DI1 is on, DI2...DI5 are off.
0161 PULSE INPUT FREQ
Value of frequency input in Hz
0162 RO STATUS
Status of relay output. 1 = RO is energized, 0 = RO is de-energized.
04 FAULT HISTORY
Fault history (read-only)
0401 LAST FAULT
Fault code of the latest fault. See chapter
Fault tracing
on page
127
for the codes. 0 =
fault history is clear (on panel display = NO RECORD).
0402 FAULT TIME 1
Day on which the latest fault occurred.
Format: The number of days elapsed after power-on.
0403 FAULT TIME 2
Time at which the latest fault occurred.
Format: Time elapsed after power-on in 2 second ticks (minus the whole days stated by
signal
0402
FAULT TIME 1). 30 ticks = 60 seconds.
For example, value 514 equals 17 minutes and 8 seconds (= 514/30).
0404 SPEED AT FLT
Motor speed in rpm at the time the latest fault occurred
0405 FREQ AT FLT
Frequency in Hz at the time the latest fault occurred
0406 VOLTAGE AT FLT
Intemediate circuit voltage in V DC at the time the latest fault occurred
0407 CURRENT AT FLT
Motor current in A at the time the latest fault occurred
0408 TORQUE AT FLT
Motor torque in percent of the motor nominal torque at the time the latest fault occurred
0409 STATUS AT FLT
Drive status in hexadecimal format at the time the latest fault occurred
0412 PREVIOUS FAULT 1
Fault code of the 2nd latest fault. See chapter
Fault tracing
on page
127
for the codes.
0413 PREVIOUS FAULT 2
Fault code of the 3rd latest fault. See chapter
Fault tracing
on page
127
for the codes.
0414 DI 1-5 AT FLT
Status of digital inputs
DI1…5 at the time the latest fault occurred. Example: 10000 = DI1
is on, DI2...DI5 are off.
Summary of Contents for ACS150 series
