Actual signals and parameters
116
Parameters in the Long parameter mode
Index
Name/Selection
Description
Def
3304
DRIVE RATING
Displays the drive current and voltage ratings.
0x0000 hex
0000
…FFFF hex
Value in format XXXY hex:
XXX = Nominal current of the drive in amperes. An
“A” indicates decimal
point. For example if XXX is 8A8, nominal current is 8.8 A.
Y = Nominal voltage of the drive:
1 = 1-phase 20
0…240 V
2 = 3-phase 20
0…240 V
4 = 3-phase 38
0…480 V
34 PANEL DISPLAY
Selection of actual signals to be displayed on the panel
3401
SIGNAL1 PARAM
Selects the first signal to be displayed on the control panel in the Output
mode.
3401
3404
3405
LOC
49
.
1
Hz
OUTPUT
FWD
103
0, 10
1…162
Parameter index in group
01 OPERATING DATA
. For example, 102 =
0102
SPEED. If value is set to 0, no signal is selected.
If parameter
3401
SIGNAL1 PARAM,
3408
SIGNAL2 PARAM and
3415
SIGNAL3 PARAM values are all set to 0, n.A. is displayed.
3402
SIGNAL1 MIN
Defines the minimum value for the signal selected by parameter
3401
SIGNAL1 PARAM.
Display
value
3407
3406
Source value
3402
3403
Note:
Parameter is not effective if parameter
3404
OUTPUT1 DSP FORM
setting is 9 (DIRECT).
-
x…x
Setting range depends on parameter
3401
SIGNAL1 PARAM setting.
-
3403
SIGNAL1 MAX
Defines the maximum value for the signal selected by parameter
3401
SIGNAL1 PARAM. See the figure for parameter
3402
SIGNAL1 MIN.
Note:
Parameter is not effective if parameter
3404
OUTPUT1 DSP FORM
setting is 9 (DIRECT).
-
x…x
Setting range depends on parameter
3401
SIGNAL1 PARAM setting.
-
Summary of Contents for ACS150 series
