67
Control panel
Changed parameters mode
In the Changed parameters mode, you can:
• view a list of all parameters that have been changed from the macro default
values
• change these parameters
• start, stop, change direction, switch between local and remote control and set the
frequency reference.
How to view and edit changed parameters
Step
Action
Display
1.
Go to the Main menu by pressing
if you are in the Output mode,
otherwise by pressing
repeatedly until you see MENU at the bottom.
LOC
rEF
MENU
FWD
2.
If the panel is not in the Changed parameters
mode (“PArCh” not visible),
press key
or
until you see
“PArCh” and then press
. The
display shows the number of the first changed parameter and PAR is
flashing.
LOC
PArCh
MENU
FWD
LOC
1103
PAR
FWD
3.
Use keys
and
to find the desired changed parameter on the
list.
LOC
1003
PAR
FWD
4.
Press and hold
for about two seconds until the display shows the
value of the parameter with
SET
underneath indicating that changing of the
value is now possible.
Note:
When
SET
is visible, pressing keys
and
simultaneously changes the displayed value to the default value of the
parameter.
LOC
1
PAR
SET
FWD
5.
Use keys
and
to select the parameter value. When you have
changed the parameter value,
SET
starts flashing.
• To save the displayed parameter value, press
.
• To cancel the new value and keep the original, press
.
LOC
2
PAR
SET
FWD
LOC
1003
PAR
FWD
Summary of Contents for ACS150 series
