2-8
IM AQ1300-01EN
Summary
A summary of the settings is displayed, or the addresses are displayed.
• Summary: Representative settings are displayed.
Test Mode
Displayed Items
Traffic Test
Tx rate; Tx time (when Tx Mode is set to Time), number of frames (when Tx Mode is
set to Frames), or elapsed time (when Tx Mode is set to Continuous); frame length;
fill pattern
Loopback Test
Loopback target
QoS Test
Tx rate for each channel
PING Test
Destination IP address, Tx interval, Tx time (when Tx Mode is set to Time), number
of frames (when Tx Mode is set to Frames), or elapsed time (when Tx Mode is set to
Continuous)
BERT
Tx rate; Tx time (when Tx Mode is set to Time), number of frames (when Tx Mode is
set to Frames), or elapsed time (when Tx Mode is set to Continuous); frame length
• Address: The source and destination MAC and IP addresses are displayed.
For information about switching between the summary and the address display, see section 7.6.
Test-Mode-Specific Indications
A summary of the test results is displayed.
Test Mode
Displayed Items
Traffic Test
Maximum Rx rate (%, fps, bps), maximum packet latency (us)
Average Rx rate (%, fps, bps), average packet latency (us)
Loopback Test
None
QoS Test
Maximum Rx rates for each channel (%, fps, bps)
Average Rx rates for each channel (%, fps, bps)
Current Rx rates for each channel (%, fps, bps)
PING Test
Loss count, sequence number, round trip time, packet length, TTL
BERT
Bit error rate, bit error, BERT target byte
Explanations of PING Test Mode Items
Indication
Description
Loss Count
Indicates the number of failed ping attempts
Seq. No.
Indicates the sequence number.
Round Trip Time(ms)
Indicates the round trip time in ms.
<1:
Indicates a value of less than 1 ms
Value:
The value in ms
Timeout: Indicates a timeout
Length
Indicates the packet length.
TTL
Indicates the TTL.
2.2 Measurement Screens (Test-mode-specific items)
