6-18
IM AQ1300-01EN
Frame Setting Screen
Press
Detail
next to Frame Structure to display the following screen.
Select this check box to refer to the
source address for the VLAN settings.
Set the VLAN stack number (None, 1, 2).
This setting is valid when the “Refer to
Source Address for the VLAN Setting”
check box is cleared.
Set the frame structure
(MAC+TYPE, MAC+TYPE+IPv4,
MAC+TYPE+IPv4+UDP,
MAC+TYPE+IPv6,
MAC+TYPE+IPv6+UDP).
Note
The AQ1300/AQ1301 will receive the type of frames specified by the Frame Structure setting.
Rx Base Filter Setting Screen
Press
Detail
next to a filter to display the following screen.
Set the method
(Field, Offset).
Set the field.
This setting is valid when Method is set
to Field.
(MAC-DA, MAC-SA, VLAN-ID,
VLAN-CoS, IPv4-ToS, IPv4-DSCP,
IPv4-DA, IPv4-SA, IPv4-Protocol,
IPv6-DA, IPv6-SA, IPv6-TrafficClass,
IPv6-DSCP, IPv6-NextHeader, L4-DP,
L4-SP)
The items that you can set vary
depending on how the settings in the Rx
Setting screen and the frame structure
and VLAN settings in the Frame Setting
screen are configured.
Set the offset.
This setting is valid when Method is set
to Offset.
Offset (0-255 bytes).
Bit/Mask
Bit offset (0-47 bits)
Bit width (1-48 bits)
This setting appears when Bit/Mask is
set to Bit.
Set the input format (DEC, HEX, IPv4).
Set the pattern.
Set the byte length (1-6 bytes) and the
master pattern.
This setting appears when Bit/Mask is set
to Mask.
6.5 Configuring a Traffic Test
