WTC MedWeld 3005, Руководство оператора

Страница: 160 / 206

6Qe\d3_^TYdY_^c
(( =UTGU\T# %?`UbQd_bµc7eYTUD)## "
= #" "%1`bY\" "
Isolation
Contactor
Off When
Needed
(See p. 6-5)
The isolation contac-
tor was not pulled in
by the control when
required by the weld
schedule. The instruction to activate the
isolation contactor (Function
#52) was missing from the
weld schedule. Verify that the schedule
contains Function #52.
Isolation contactor is con-
trolled by the weld control and
driven by a single solid-state
relay. The weld processor
signal is based on the status
of the CONTROL STOP and
WELD/NO WELD Inputs.
(Voltage must be present at
these inputs to allow the weld
processor to open or close
the isolation contactor.) Use the I/O Status display on
the DEP-100S to verify that the
inputs are high (1) when
required.
Verify that the Ready to Weld
signal was high (1) when
required.
For externally-powered
controls, an internal control
transformer fuse is blown. Check fuses; replace as
necessary.
The solid-state relay is faulty. Replace relay.
The instruction to activate the
isolation contactor was exe-
cuted, but the control was
unable to pull in the contactor,
due to incorrect or loose wir-
ing to the output module. Check the wiring diagram that
came with your control for
proper I/O designations. Verify
that all wiring connections are
secure.
Faulty output module. Replace module.
Message Explanation Possible Cause Remedy