WTC MedWeld 3005, Руководство оператора

Страница: 154 / 206

6Qe\d3_^TYdY_^c
(" =UTGU\T# %?`UbQd_bµc7eYTUD)## "
= #" "%1`bY\" "
Fault Page
RETRACT PILOT ERROR
. . . . . . . . . . . . . . . . . . . . . . . . . 6-8
SCR MISFIRE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-5
SLC NOT IN RUN MODE. . . . . . . . . . . . . . . . . . . . . . . . 8-11
SLOW CYLINDER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-5
STEPPER APPROACHING MAX . . . . . . . . . . . . . . . . . 8-3
SURE WELD TREND LIMIT . . . . . . . . . . . . . . . . . . . . . . 8-3
SYSTEM COOLING . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-10
TIPS TOUCHING/TIPS NOT TOUCHING . . . . . . . . . . . 8-5
VOLTAGE COMPENSATION. . . . . . . . . . . . . . . . . . . . . 8-7
WELD CURRENT SHUNTING . . . . . . . . . . . . . . . . . . . 8-12
WELD INITIATE NOT PRESENT. . . . . . . . . . . . . . . . . . 8-2
WELD INTERRUPT . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-10
WELD PROCEED . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-11
Message Explanation Possible Cause Remedy
Invalid
Sequence
Selected
(See p. 6-2)
The combination of
BINARY SELECT
inputs was invalid. The weld initiate was on but
no BINARY SELECT inputs
were active. Turn on the BINARY SELECT
input(s) required.
The PARITY input failed to
provide an odd number of
inputs. Check the number of BINARY
SELECT inputs used to select
the schedule number. If this is
an even number, activate the
PARITY input.
Incorrect or loose wiring at
the input module. Check the wiring diagram for
proper I/O designations. Verify
that all wiring connections are
secure.
Bad connectors, improper
seating or faulty SLC proces-
sor, input module or weld
processor module. Remove power, re-seat mod-
ules and replace as necessary.
Weld Initiate
Not Present
(See p. 6-2)
The WELD INITIATE
input was not active
when checked by the
control in Function
#50. Weld schedule contains
Function #50, but the function
is not required by the applica-
tion. Remove Function #50 from the
weld schedule.
The robot or PLC ladder logic
is not holding the INITIATE
input high the amount of time
required by the application. Repair robot or ladder logic
program.