WTC MedWeld 3005, Руководство оператора

Страница: 199 / 206

DeviceNet I/O Tables
dnet_map Welder Inputs—Node 30
Host Output Image Table (Node 30)
Bit
Global SCR#1 SCR#2 SCR#3 SCR#4 SCR#5 SCR#6
Byte 0
a
a. The I/O active will be set if the control slot is enabled and supported. The respective Byte 0 Input bit must be set for the control to be enabled. If the
bit is not set, the respective device is not required to be in the SLC rack.
Byte 1
b
b. For definitions of the signals in bytes 1-7, refer to “I/O Definitions” on page 3-5.
Byte 2
b
Byte 3
b
Byte 4
b
Byte 5
b
Byte 6
b
Byte 7
b
00 ENABLE SCR#1 CONTROL STOP BINARY
SELECT #1 BINARY
SELECT #1 BINARY
SELECT #1 BINARY
SELECT #1 BINARY
SELECT #1 BINARY
SELECT #1
01 ENABLE SCR#2 ENABLE CONTACTOR
SAVER BINARY
SELECT #2 BINARY
SELECT #2 BINARY
SELECT #2 BINARY
SELECT #2 BINARY
SELECT #2 BINARY
SELECT #2
02 ENABLE SCR#3 GLOBAL STEPPER
RESET BINARY
SELECT #4 BINARY
SELECT #4 BINARY
SELECT #4 BINARY
SELECT #4 BINARY
SELECT #4 BINARY
SELECT #4
03 ENABLE SCR#4 GLOBAL FAULT RESET BINARY
SELECT #8 BINARY
SELECT #8 BINARY
SELECT #8 BINARY
SELECT #8 BINARY
SELECT #8 BINARY
SELECT #8
04 ENABLE SCR#5 SCR #1 TIPS DRESSED BINARY
SELECT #16 BINARY
SELECT #16 BINARY
SELECT #16 BINARY
SELECT #16 BINARY
SELECT #16 BINARY
SELECT #16
05 ENABLE SCR#6 SCR #2 TIPS DRESSED INITIATE
WELD INITIATE
WELD INITIATE
WELD INITIATE
WELD INITIATE
WELD INITIATE
WELD
06 Reserved
MACHINE OUTPUT #1
C
c. The machine output will control a local output on the I/O card of the control. The status of this local machine output will directly reflect the status of
the DeviceNet input.
WELD/
NO WELD WELD/
NO WELD WELD/
NO WELD WELD/
NO WELD WELD/
NO WELD WELD/ N
O WELD
07 Reserved
MACHINE OUTPUT #2
C STEPPER
RESET STEPPER
RESET STEPPER
RESET STEPPER
RESET STEPPER
RESET STEPPER
RESET