Wincor Nixdorf TH180, Руководство программиста

Страница: 70 / 162

TH180 Programmer’s Guide
65
FS p n m
[Designation] Print in NV bit mode image
[Format] 1CH, 70H, n, m
[Valid limits] 1 n 255
0 m 3, 48 m 51
[Initial value] Cancel
[Function] (1) Prints NV bit image n in mode m.
m Mode Vertical dot
density
Horizontal dot
density
0, 48 Normal mode
203 DPI 203 DPI
1, 49 Double character width
mode
203 DPI 101 DPI
2, 50 Double character height
mode
101 DPI 203 DPI
3, 51 Quadruple size mode
101 DPI 101 DPI
(2) n specifies an NV bit image number.
(3) m specifies bit image mode.
(4) The NV bit image is such that a NV defines a non-volatile memory bit image
(FS q) to enable printing by this command.
(5) This command is invalid if specified NV bit image n is undefined.
(6) With standard mode selected, this command is valid only if the print buffer
contains no data.
(7) With page mode selected, this command is invalid.
(8) This command does not affect print modes (such as emphasized printing,
double printing, underlining, character size specification, white/black reverse
printing, and 90-degree right rotation) other than inverted (upside-down)
printing.
(9) If the print area width specified using the Set left margin command (GS L) or
the Set printing area command (GS W) is smaller than the minimum horizontal
width in NV bit image mode, the processing given below is performed only for
that line.
The minimum horizontal width is one dot for normal mode (m = 0, 48) and
double character height mode (m = 2, 50), two dots for double character width
mode (m = 1, 49) and quadruple size mode (m = 3, 51).
a. The print area is enlarged to the right until it is equivalent to the minimum
horizontal width of the NV bit image.
b. If the processing operation in a. above cannot allocate a sufficient area, the
print area is enlarged to the left. (The left margin is reduced.)
(10) If a bit images with a size exceeding the print area have been specified, data
in the print area is printed, but data outside of this area is not printed.