Wheatstone Corporation WheatNet-IP Blade3s, Техническое руководство

Страница: 202 / 283

A P P E N D I C E S
page A – 27
WheatNet-IP / Apr 2009
page A – 16.11
WheatNet-IP / Feb 2010
Now that you are in the Global configuration mode you need to select the interface that
you would like to configure. We’ll start with the default VLAN.
The switch will come with a default VLAN enabled. In the default configuration all
ports on the switch have been assigned to VLAN1 (DEFAULT_VLAN). The command
below selects the default VLAN for configuration to segment network traffic on the
switch. If you are adding an additional VLAN to existing hardware, substitute that VLAN
number in place of 1.
Enter the following commands (“XXX” = the actual network IP address)
V l a n 1 V l a n 1
V l a n 1 V l a n 1
V l a n 1
ip address 192.168.87.XXX 255.255.255.0
ip address 192.168.87.XXX 255.255.255.0
ip address 192.168.87.XXX 255.255.255.0 ip address 192.168.87.XXX 255.255.255.0 ip address 192.168.87.XXX 255.255.255.0
e n d
e n d e n d e n d e n d
Let’s look at what you just setup. By typing “Vlan1” you are entering the configuration
for that VLAN. The “IP Address” Command simply sets the IP address of the VLAN1
interface for remote management purposes. The IP address must be unique on the
network.
IGMP Querier Configuration
By default, IGMP is disabled globally on the switch. To setup IGMP Multicast
filtering on the switch you must be in the Global configuration mode. To enter the
configuration mode once again type “Config T” and press enter.
Enter the following commands:
ip igmp ip igmp ip igmp ip igmp ip igmp
ip igmp querier
ip igmp querier ip igmp querier ip igmp querier ip igmp querier
e n d
e n d
e n d e n d
e n d
The commands above simply enable IGMP on the default VLAN and the querier on
the switch.
Configuring Gigabit Ports Connecting to WheatNet-IP I/O Blades
and PC Drivers
Configuring the ports on the HP Procurve Series 2810 is a key step in ensuring optimal
performance of the WheatNet-IP network. This section will guide you in the setup of each
port used for WheatNet-IP I/O Blades.
To setup ports on the switch you must also be in the Global Configuration mode. To
enter the configuration mode once again type “Config T” and press enter.
Enter the following commands
Interface X (X=the Ethernet port being configured) Interface X (X=the Ethernet port being configured)
Interface X (X=the Ethernet port being configured) Interface X (X=the Ethernet port being configured) Interface X (X=the Ethernet port being configured)
speed 1000-FULL
speed 1000-FULL speed 1000-FULL speed 1000-FULL speed 1000-FULL
e n d
e n d e n d e n d e n d
Ports on the HP Procurve can be configured individually or in a “Range.” If range is
desired type Interface 1 - 24 (for example), using the desire number of ports.