Welch Allyn Connex IWS, Инструкция по применению

Страница: 59 / 266

1. Insert the power plug into an outlet to power the monitor and to charge the battery.
Note New batteries are only 30 percent charged. You must plug
the wall system into AC power to fully charge the battery.
Do not plug in the power cord until completing all preliminary
steps.
2. Proceed to Startup.
Attach an accessory
1. Shut down the wall system and detach the power cord. Then remove the cover from
the wall system by loosening the captive retention screws.
2. Loosen the two screws on the cable retention clamp and remove it. Then connect
the USB cable(s) to an available connector and thread the cable(s) through the cable
guide(s).
3. Replace the cable retention clamp and tighten the two screws.
4. Re-attach the cover.
a. Thread the SpO2 (or SpHb) cable through the cutouts on the top right and
bottom left of the cover.
Directions for use Setup 53