Welch Allyn Connex IWS, Инструкция по применению

Страница: 64 / 266

Reset the monitor
If the monitor stops functioning, you can press and hold for approximately 6
seconds to allow the hardware to completely cycle off and to reset the monitor
configuration settings to the last saved default power-up configuration. The button is
located on the side of the monitor and on the front of the wall system.
CAUTION Do not use a long press of to power down the monitor or
wall system when it is functioning normally. You will lose patient data and
configuration settings.
Enter clinician information
1. Go to the Clinician tab using one of these methods:
• On the Home tab, touch the Clinician ID section of the Device Status area (top
left corner of the screen).
• Touch the Settings > Clinician tab.
2. To enter the clinician name, touch , located at the right of the text field, and
enter characters.
You can enter up to 32 characters for the clinician's first and last name. Enter only 1
character for the middle initial.
3. To enter the clinician ID, use one of these methods:
• Touch and enter the ID.
• Scan the clinician's barcode with a barcode scanner.
Note If "Require clinician ID match to save measurements" is
enabled in Advanced settings, a progress indicator appears in
the Device Status area as the device queries an external host
system for a matching ID.
•
An unsuccessful query results in the message, "Unable to identify
clinician."
• A successful query results in clinician data replacing the progress
indicator according to preferences configured in Advanced settings.
4. If prompted, enter your system password in the Authentication pane.
5. Touch
OK to save your entries and return to the Home tab.
58 Startup Welch Allyn Connex
®
Devices