Welch Allyn Connex IWS, Инструкция по применению

Страница: 151 / 266

The new intervals take effect at the start of the next NIBP measurement.
Stat intervals
You can configure the monitor to take NIBP measurements continuously.
When you select the Stat option, the monitor takes repeated NIBP measurements for 5
minutes, starting a new cycle each time the cuff deflates below safe venous return
pressure (SVRP) for 2 seconds.
WARNING
Patient injury risk. If you use Stat mode repeatedly, periodically
observe the patient's limb to ensure that circulation is not impaired and that
the cuff remains in place. Prolonged impairment of circulation or improper
cuff position can cause bruising.
Current cuff pressures are not dynamically displayed during a Stat reading. The Home
tab displays the NIBP reading from the previous cycle until the current cycle finishes.
Note
If you are in Stat intervals, you can stop intervals by touching .
Start Stat intervals
Follow these steps to start Stat intervals.
1. Properly size the blood pressure cuff and position it around the patient’s bare upper
arm.
2. On the Home tab, touch .
3. Select Stat .
4. Touch Start intervals .
The Home tab appears with the intervals timer counting down from 0:05:00.
Stop intervals measurements
Follow these steps to turn off intervals.
Directions for use Patient monitoring 145