Welch Allyn Connex IWS, Инструкция по применению

Страница: 122 / 266

Custom scoring
WARNING
Risk to patient safety. Custom scores and messages serve as
guides to your facility's protocols;
do not subsitute custom scores for
patient physiological alarms . Appropriate alarms settings must be set
and maintained to ensure patient safety.
Custom scoring enables you to configure specific parameters, based on your institution’s
practice standards, that calculate a score(s) for patient monitoring. This score(s)
generates a message(s) regarding the patient status, based on the parameters chosen.
These messages are provided only as reminders.
Configurable parameters can be accessed on the Home tab by touching Height/
Weight/Pain/RR .
Manual overrides
The manual override feature enables you to do the following:
•
input measurements when none have been recorded on the device
• replace the currently displayed measurements with measurements you take
manually
Enter a manual override measurement
Follow these steps to enter a manual measurement.
1. Press and hold the selected parameter frame until a keypad appears.
2. Enter the manually acquired measurement on the keypad and touch
OK .
The Home tab appears and displays the entered measurement.
Note Touch Clear to remove all values and correct your entry as needed.
Note In the Continuous Monitoring profile, measurements entered manually
remain on the screen for one minute. In the episodic profiles, the manual
measurement remains in the frame until the next measurement is taken.
Patient movement
Monitors configured with the EarlySense™ module continuously monitor patient
movement, as well as Respiration rate (RR) and Pulse rate if licensing is enabled for
these functions.
Note
Respiration rate and Pulse rate measurements taken by the EarlySense
module are displayed in the RR and Pulse rate frames, respectively. The
frame remains blank until the sensor acquires its first measurements,
which could take 1 to 2 minutes. After the initial measurement, a process
indicator appears in the frame if a lost or low signal condition occurs. Lost
or low signal conditions that last more than 3 minutes trigger an alarm. See
the Respiration rate and Pulse rate sections of this directions for use for
more information.
116 Patient monitoring Welch Allyn Connex
®
Devices