Wacker Neuson BS 50-4s, BS 50-4As, Руководство по ремонту

Страница: 21 / 194

wc_tx004062gb_FM10.fm
21
Rammer Operation
2.3 Starting, Operating, and Stopping the Machine—WM 100
Requirements
■
Rammer is in serviceable condition and has been properly maintained.
■
There is fuel in the tank.
Starting the
machine Perform the procedure below to start the machine.
1. Set the throttle to the idle position (c
2
) . This will automatically start the flow of
fuel.
2. Close the choke (a) .
3. Pump the purge bulb (b) 6–10 times or until you see fuel in the bulb.
Note: The engine will not become flooded by pumping the purge bulb more than 10
times. Pumping the purge bulb removes air from the fuel system. It does not pump
fuel into the carburetor.
4. Pull the starter rope repeatedly until the engine starts.
Multiple pulls of the starter rope (usually fewer than five) may be required to start
an engine:
■
on a new machine being operated for the first time
■
that has not been run for a long period of time (a week or more)
■
that has been run completely out of fuel
■
in cold weather conditions
This procedure continues on the next page.
wc_gr011596
c
1
c
2
c
3
b
a