ViaSat 8116 Series, Инструкция по установке и эксплуатации

Страница: 40 / 188

LOWER MOUNT INSTALLATION PROCEDURES
After the mount is torqued the mount door and frame should be
assembled and then installed from the inside of the mount in accordance
with the following procedures.
Door Assembly and
Installation
1. From inside mount, place right door skin (item 14, Figure 2-3) with
small end pointing toward door opening and short flange on floor and
turned toward outside of door.
2. From inside mount, locate left door skin (item 15) on floor with small
end pointing toward door opening and short flange on floor and turned
opposite from the flange in step 1 above.
3. Locate top door skin (item 16) across the narrow end of left and right
door skins. The long flange should be placed on the floor and end
flanges overlapping on outside of door skins.
4. Secure top door skin to left and right door skins in two places each side
using screw, two flat washers, and nut (item 108, 109, and 110).
5. Install one door side channel (item 18) on right door skin.
6. Secure door side channel in six places using screw, two flat washers,
and nut (item 108, 109, and 110). Torque to 31 ft-lbs
(42 Nm).
7. Install one door side channel (item 18) on left door skin.
8. Repeat step 6.
9. Locate door top channel (item 17) on upper door skin.
10. Secure door top channel four places using screw, two flat washers, and
nut (item 108, 109, and 110). Torque to 31 ft-lbs (42 Nm).
11. With one person on each side of door assembly (item 111), lift
assembly and slide it onto the door side channels until door frame top
covers door top channel.
NOTE
Make sure that the door will open inward when erected in the
door opening.
12. Check that door frame rails are touching right and left door skins and
completely hitting door side channels.
13. Check that top door frame rail is touching top door skin and hitting
door top channel.
14. With door frame and side skin panels still laying on the ground, drill
two holes in top of door frame and door top channel and secure door
frame in place using self tapping screw (item 106).
15. With door frame and skin panel still laying on the floor, drill two pilot
holes equally spaced through top door frame and top door channel
using drill bit (item 107, Figure 2-3) and secure with self tapping
screws (item 106).
____________________________________________________________________________________________
2-24
SERIES 8116/8118 16-/18-METER EARTH STATION ANTENNA
42S183D