Tuttnauer 6671130, Руководство по эксплуатации и техническому обслуживанию

Страница: 62 / 143

MAN205-0195042EN Rev. A Aug. 2011
Page 56 of 137 pages
Select PT100
There are 2 temperature sensors that regulate cycles:
1. Sensor 1: (double) in the condensate line: PT100
– No. 1
2. Sensor 5: in the drain line PT100
– No 5
This is the final parameter under Code 13. Pressing ENTER returns the display to the
ST.BY screen.
Entry code 13
Resolution 1
Minimum value 1
Maximum value 5
Stay Time - Delay time between heating and sterilization
This parameter allows partial entry to the sterilization stage with a reduction of the
overshoot and the reduction difference between the different sensors that are entered
into the chamber for control or validation.
In the Heating Stage the system will stop heating before entering Sterilization according
to the STAY TIME value. When this value is set to 2 minutes, the system will stop 2ºC
before entering sterilization and will proceed at a rate of 1ºC/min during the STAY TIME.
Entry code 11
Resolution 1 minute
Minimum value Ø minute
Maximum value 15 minutes
This is the final parameter under Code 11. After pressing ENTER the display will return
to the ST.BY screen
Dry Vac. - Dry Vac. =0;
Entry code
11
Resolution 1 (Mode)
Minimum value Ø
Maximum value 90
Bio Cycle
Entry code 33
Resolution 1 (Mode)
Minimum value Ø
Maximum value 1
Air Detector
Entry code 33
Resolution 1 (Mode)
Minimum value Ø
Maximum value 1