Tuttnauer 2301006, Руководство по эксплуатации и техническому обслуживанию

Страница: 74 / 122

Page 69 of 117 pages
7. PREPARATION BEFORE STERILIZATION
Instruments to be sterilized must be clean, free from any residual
matter, such as debris, blood, pads or any other material. Such
substances may cause damage to the contents being sterilized and to
the sterilizer.
1. Wash instruments immediately after use, to dispose of any residue.
2.
Follow manufacturer's instructions on the use of products for cleaning
and lubricating instruments after using the ultrasonic cleaner.
3. Before placing an instrument into the sterilizer tray, make sure that
the instruments which are not of the same metal (stainless steel,
carbon steel, etc.) are separated and placed in different trays.
Note: Check manufacturer's instructions for sterilization of each item.
4. In case of carbon steel instruments are used with stainless steel trays,
the tray should be lined with a towel or paperwrap before placing the
instrument. There should be no direct contact between the carbon
steel and the stainless steel trays.
5. All instruments must be sterilized in an open position.
6. Place a sterilization indicator strip in each tray.
7. Once a week use a biological spore test indicator in any load to
ensure sterilization.
8. Make sure that all the instruments remain apart during the sterilization
cycle.
9. Empty canisters should be placed upside-down in order to prevent
accumulation of water.
10.
Do not overload sterilizer trays. Overloading will cause inadequate
sterilization and drying.
11. Allow a distance of approximately 1" between trays to permit
circulation of steam.
12. Wrapped instruments should be packed in material which promotes
drying, such as autoclave bag, autoclave paper, muslin towels.
NOTE:
Verify that the packaging method is in accordance with Good Practice
approach and the packaging materials are in accordance with the
applicable standards (e.g. EN868 series).