Tuttnauer 2301006, Руководство по эксплуатации и техническому обслуживанию, Страница: 82 / 122

Page 77 of 117 pages
10.2 Printer Handling
The printer is driven and controlled automatically by the control
unit, while the autoclave performs a sterilization program.
Figure 1 Figure 2
To set the paper roll in the printer perform the following steps:
10.2.1
Gently push the clips for removing the front panel,
remove the panel and pull out the printer gently.
10.2.2 Set the paper roll on the shaft (See Figure 1). Since the
outer and inner surfaces of the paper are different set
the roll so that the printing surface is the outer.
10.2.3 Gently push the paper face down into insertion opening
(A) in Figure 2. Keep pressing the feed switch (B) until
the paper comes out from the print head (C).
10.2.4 When the paper emerges from the print head, insert it
in the paper cutter (the slot in the front panel) and
reassemble the front panel on the unit.
The paper roll is set inside the unit and the printer is ready for
use.
NOTE: If the paper is not pulled in by the rollers even when
you press the feed switch (B) push the paper in.
10.2.5 To ensure a reliable operation of the printer perform the
following:
10.2.5.1 Turn the main switch to the OFF position.
10.2.5.2 Turn the main switch to the ON position;
press the feed switch at the same time.
Verify that the printer performs an operation
test by printing all the built-in characters
The following precautions have to be taken ensuring the
proper operation of the printer:
♦
Avoid contact between the paper and the hot parts of
the autoclave, as the paper will be blackened.
♦
Do not pull out the paper roll from the paper insertion
opening.
♦
Use only the 58mm. wide thermal paper rolls, supplied
by your dealer.