Tuttnauer 2301006, Руководство по эксплуатации и техническому обслуживанию, Страница: 71 / 122

Page 66 of 117 pages
5.1.2 Temp 2:
Temperature of sensor 2 on the condense line.
Refer to Temp1 for instructions.
5.1.3 Temp 3 (Option):
Temperature of sensor 1.
Refer to Temp1 for instructions.
5.1.4 Temp 4 (Option):
Temperature of sensor 2.
Refer to Temp1 for instructions.
Temp 5 - For drain control output
Temperature of sensor 5.
Refer to Temp1 for instructions.
5.1.5 Chm Pres: (Chamber Pressure)
This screen requests a code to be entered.
Press the UP key once, to enter the value ØØ1 and press ENTER.
This provides the screen giving 4 pressure values:
A100 R100
A300 R300
Pressing the far right command key (F3) allows you to pass to the different
values, which may be changed using the UP/DN key only.
After F3 is pressed when it is on the last value, it moves on to the next screen.
Pressing the middle command key (F2) reads the value of the sensor.
Pressing STOP will stop the cycle.
5.1.6 Jkt Pres: (Jacket Pressure)
Jacket Pressure.
Refer to Chm Prs for instructions.
5.1.7 Gen Pres:
Generator Pressure.
Refer to Chm Prs for instructions.
5.1.8 D1 Pres:
Pressure in Gasket1.
Refer to Chm Prs for instructions.
After Enter is pressed, the Calibration options are concluded and the display
returns to the ST.BY screen.
This calibration method enables the technician to change a certain point
without affecting a second point.
E.g.: When we work at 273
º
F and at 250
º
F and during the temperature
checking for 273
º
F, the thermocouple introduced in the chamber indicates
the actual temperature 270
º
F; when we work at 250
º
F the thermocouple
indicates the actual temperature in the chamber 250
º
F.