Tuttnauer 2301006, Руководство по эксплуатации и техническому обслуживанию

Страница: 77 / 122

Page 72 of 117 pages
Drain
Connect the following outlets directly to a drain funnel. Or connect them
through a drain collector pipe of 2” that should be covered. The drain system
should be vented.
♦
The exhaust from the chamber by a 1” pipe.
♦
The drain-cooling by a 1/2” pipe.
♦
The condensate from jacket by a 3/4" pipe.
♦
The discharge from ejector by a 1" pipe.
♦
The steam generator drainage by a 3/4‘’ pipe.
Power connection
♦
Connect the power cord, one phase, Neutral and Grounding to the
terminals in the electrical box and the ground wire- GND to the grounding
screw connection.
♦
The power outlet for the electrical supply is, 115 V/ 60 Hz.
Preliminary Checks
After installation and prior to putting the machine into operation, the following
preparation and checks should be followed:
♦
Check the water and drain inlets are connected correctly to the utilities
and the manual taps on the external lines and the autoclave piping, are
open.
♦
Check the manual bypass screws (on the base of the pilot solenoid
valves) are set in neutral position, i.e. the slit on the head of the screw is
set in horizontal position.
♦
Search for leakage and fix piping joints if necessary.
♦
Check feed water pressure at the autoclave inlet complies with the
requirements.
♦
Check the electrical network switchboard if the autoclave circuit is
switched on, and fuses or circuit breakers are not interrupted, also
checking if the correct voltage is present in the autoclave control box
according to specifications.
♦
Check the circuit breakers in the control box are switched on.
If the results of the above checks are positive, the autoclave is ready
for operation.