Toshiba Q7 Flow, Инструкция по установке и эксплуатации, Страница: 116 / 174

110 Q7 ASD Installation and Operation Manual
RX2 Torque Reference #1
Program
⇒
Freq Settings
⇒
RX2 Torque Ref #1
This parameter is used to set the direction, gain, and bias of the RX2 input
terminal when the RX2 terminal is used as the control input while operating in
the Torque Control mode.
RX2 Input Torque Control Setup
Perform the following setup to allow the system to receive Torque control input
at the RX2 input terminal:
• Program
⇒
Utility Group
⇒
Frequency Mode
⇒
Rx.
• Program
⇒
Utility Group
⇒
Command Mode
⇒
Terminal Block.
• Provide a Run command (F and/or R).
Torque Control
Perform the following setup to allow the system to perform Torque control
from the RX2 input terminal:
• Set RX2 Torque Reference #1,
• Set the RX2 input signal level (RX2 Speed Ref #1) that represents the RX2
Torque Reference #1,
• Set RX2 Torque Reference #2 , and
• Set the RX2 input signal level (RX2 Speed Ref #2) that represents the RX2
Torque Reference #2 .
This is accomplished by establishing an associated V/f output pattern for a
given RX2 input level.
This parameter sets RX2 Torque Reference #1 and is the output torque value
that is associated with the setting of
RX2 Speed Reference #1 when operating
in the Torque control mode.
This value is entered as -250 to +250% of the rated torque.
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — -250.0
Maximum — +250.0
Units — %
Torque Settings
RX2 Torque Reference #2
Program
⇒
Freq Settings
⇒
RX2 Torque Ref #2
This parameter is used to set the direction, gain, and bias of the RX2 input
terminal when the RX2 terminal is used as the control input while operating in
the Torque Control mode.
This is accomplished by establishing an associated V/f output pattern for a
given RX2 input level.
See RX2 Torque Reference #1 for further information on this setting.
This parameter sets RX2 Torque Reference #2 and is the output torque value
that is associated with setting of
RX2 Speed Reference #2 when operating in
the Torque control mode.
This value is entered as -250 to +250% of the rated torque.
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — -250.0
Maximum — +250.0
Units — %
RX2 Torque Reference #1 RX2 Torque Reference #2