Page
C-23
OPERATING INSTRUCTIONS
Document 57.0003.4200 - 03/2005
Handler with telescopic boom
Agrilift 625 - Telelift 2506
C-4 SETUP
■
C-4.1
BEFORE STARTING THE ENGINE
•
To ensure safe conditions to the operators and the
bystanders, and a longer life to your machine,
perform a walk-around inspection before starting
the engine.
•
Remove any dirt or rubbish from the cab interior,
and especially from pedals and control levers.
•
Remove oil, grease and mud from pedals and
control levers.
•
Make sure that your hands and shoe soles are clean
and dry.
•
Check the seat belts can be fastened properly.
•
Check that lights, indicators, side/tail lights, hazard
indicator lights, wipers and horn are in working
order.
•
Adjust the driving seat so that you can reach all
control levers comfortably and fully depress the
brake pedal without moving your back from the
driving seat.
•
Adjust the rear view mirrors to give you a good
view close behind the machine when you are
correctly seated.
•
Check the parking brake is engaged.
■
C-4.1.1 Checks at the machine start-up
When power is turned on, the load limiting system
activates automatically. If the power supplied is correct,
the green light
4
above the Terex logo comes on. The
display remains off while the system runs a self-test.
After that, the system is activated and
0
appears on the
display.
If during the check phase, the load limiting system finds
a fault, it enters the safety mode automatically blocking
any dangerous manoeuvres and an error message
starts flashing on the display. For any further
information, refer to
chap. C-5.2
.
Also check the efficiency of the safety devices as
described in
chap. D-3.15
, namely:
•
overload warning system
•
joystick pushbutton
(not present in the TCE version)
•
seat micro-switch
(only in the TCE version)
•
parking brake proximity switch
•
emergency pushbutton
•
machine start control
■
C-4.2
STARTING THE ENGINE
For the low temperature starting, see paragraph C-4.4.
•
Put the mechanical gear lever to neutral.
•
Step on the gas pedal.
•
To start the engine, turn the ignition switch to
position
. Release the switch when the engine
starts. If the engine does not start within 20
seconds, release the key and wait at least 2 minutes
before attempting again.
•
After the start-up, let
the engine run at idle
for some seconds
before engaging a
gear; this allows for a
gradual warm up of the
engine oil and a better
lubrication.
•
In case of engine jump-starting, remove the booster
cables (see following chapter).
ATTENTION
If the light indicators do not switch off/on when
engine is running, immediately stop the machine
and find and rectify the fault.
IMPORTANT
Engine cannot be started if the speed switch is not
in the neutral position and the operator is not
correctly seated in the driving seat.
DANGER
After the start-up, when leaving the driving place,
the engine continues to run. DO NOT LEAVE THE
DRIVING PLACE BEFORE HAVING SHUT THE
ENGINE DOWN, LOWERED THE BOOM TO THE
GROUND AND ENGAGED THE PARKING BRAKE.
Содержание Agrilift 625
Страница 2: ...Courtesy of Crane Market ...