Instructions
Rev C
Procedure - S
®
and Z® Booms
26
Lift Connect
™
Part No. 1295251GT
9 Secure the harness to the existing cables
using the provided cable ties.
Genie part number 21121GT.
10 Locate the machine serial label.
11 Using a mild cleaning solvent, clean an area
next to the serial label. Adhere one of the
provided ESN decals to the machine.
Note: The ESN decals are provided with the
telematics module.
12 Adhere the lexan cover decal over the ESN
decal.
Genie part number 1291624GT.
Register and activate the telematics
module. Refer to page 7.
Z-45 XC
This procedure only applies to the following serial
numbers listed below.
from serial number
Z4525XCF-101 to Z45XCF-407
Z4525XCM-101
Note: Perform this procedure on a firm, level
surface with the machine in the stowed position.
1 Using a mild cleaning solvent, clean the top of
the ground control box.
1 telematics bracket
2 ground control box
2 Remove and discard the protective film from
the adhesive tape located on the bottom of the
telematics bracket.
Genie part number 1289561GT.
3 Adhere the bracket to the control box.
Note: Mount the bracket 1 inch / 2,5 cm from the
left side of the control box.
Note: The adhesive takes approximately 20
minutes to fully adhere to the surface.
