Instructions
Rev C
GS
™
Models
38
Lift Connect
™
Part No. 1295251GT
GS-2032, GS-2632, GS-3232,
GS-2046, GS-2646, GS2646 AV,
GS-3246, GS-4047
This procedure only applies to the following serial
numbers listed below.
from serial number
GS3214A-120635 to GS32P-166229
GS3215C-14336
GS4614A-118307 to GS46P-148134
GS4615C-14486
GS4615D-2217 to GS46D-15562
GS4715C-2072
GS4715D-1106
GS4716P-101 to GS47P-3309
Note: Perform this procedure on a firm, level
surface.
1 Raise the platform 7 to 8 feet / 2,1 to 2,4 m.
2 Lift the safety arm, move it to the center of the
scissor arm and rotate down to a vertical
position.
3 Lower the platform onto the safety arm.
4 Turn the key switch to the off position.
5 Using a mild cleaning solvent, clean the top of
the drive chassis next to the level sensor.
1 ground controls compartment
2 level sensor bracket
3 telematics bracket
6 Remove and discard the protective film from
the adhesive tape located on the bottom of the
telematics bracket.
Genie part number 1289561GT.
7 Adhere the bracket to the top of the chassis.
Note: Mount the bracket 4.25 inches / 10,8 cm from
the level sensor bracket and 20.5 inches / 52 cm
from the inside edge of the chassis.
Note: The adhesive takes approximately 20
minutes to fully adhere to the surface.
8 Secure the telematics module to the mounting
bracket using the provided retaining fasteners.
Genie part number 1289520GT or
1289521GT.
1 retaining fasteners
2 telematics module
3 telematics bracket
