Instructions
Rev C
GS
™
Models
40
Lift Connect
™
Part No. 1295251GT
Updating the Machine Software
1 Go to the Genie Firmware site and select
PROP LIFT
from the drop down menu under
Controller Type.
Select
Search
.
2 Under
Application Firmware
, open the
.zip
file that is appropriate for your machine.
3 Open and print the
Software Installation
Instructions
.
4 Update the machine software.
5 After the software is updated, navigate to the
Options menu on the machine and verify that
Lift Connect (Telematics) is enabled.
Register and activate the telematics
module. Refer to page 7.
GS-2669, GS-3369, GS-4069 (DC
and Bi-Energy Models)
This procedure only applies to the following serial
numbers listed below.
from serial number
GS6914-5500
Note: Perform this procedure on a firm, level
surface.
1 Raise the platform 7 to 8 feet / 2,1 to 2,4 m.
2 Lift the safety arm, move it to the center of the
scissor arm and rotate down to a vertical
position.
3 Lower the platform onto the safety arm.
4 Turn the key switch to the off position.
5 Using a mild cleaning solvent, clean the top of
the pivot link located at the steer end of the
machine.
1 telematics bracket
2 pivot link
6 Remove and discard the protective film from
the adhesive tape located on the bottom of the
telematics bracket.
Genie part number 1289561GT.