Instructions
Rev C
GS
™
Models
36
Lift Connect
™
Part No. 1295251GT
GS™ Models
GS-1330m, GS-1530, GS-1532,
GS-1930, GS-1932
This procedure only applies to the following serial
numbers listed below.
from serial number
GS3014A-134509 to GS30P-187015
GS3015C-17993
GS30MD-101 to GS30MD-680
GS3015D-2588 to GS30D-27937
Note: Perform this procedure on a firm, level
surface.
1 Raise the platform 7 to 8 feet / 2,1 to 2,4 m.
2 Lift the safety arm, move it to the center of the
scissor arm and rotate down to a vertical
position.
3 Lower the platform onto the safety arm.
4 Turn the key switch to the off position.
5 Using a mild cleaning solvent, clean the top of
the drive chassis next to the level sensor.
1 telematics bracket
2 ground controls compartment
3 level sensor
6 Remove and discard the protective film from
the adhesive tape located on the bottom of the
telematics bracket.
Genie part number 1289561GT.
7 Adhere the bracket to the top of the chassis.
Note: The adhesive takes approximately 20
minutes to fully adhere to the surface.
8 Secure the telematics module to the mounting
bracket using the provided retaining fasteners.
Genie part number 1289520GT or
1289521GT.
1 retaining fasteners
2 telematics module
3 telematics bracket
9 Connect the gateway harness to the
telematics module.
Genie part number 1289899GT.
Note: Harness connectors are keyed for proper
installation.
Component damage hazard.
Improper connections will result
in damage to the telematics
module and it is not covered
under warranty.
example of keyed harness connector
