Rev C
Instructions
Procedure - S
®
and Z® Booms
Part No. 1295251GT
Lift Connect
™
7
Procedure - S
®
and Z
®
Boom s
S-40, S-45 (includes TraX™
models)
This procedure only applies to the following serial
numbers listed below.
from serial number
S4015-20505 to S40H-28013
S4515-20505 to S45H-28013
Note: Perform this procedure on a firm, level
surface with the machine in the stowed position.
1 Using a mild cleaning solvent, clean the top of
the ground control box.
1 telematics bracket
2 ground control box
2 Remove and discard the protective film from
the adhesive tape located on the bottom of the
telematics bracket.
Genie part number 1289561GT.
3 Adhere the bracket to the control box.
Note: Mount the bracket 6 inches / 15 cm from the
right side of the control box.
Note: The adhesive takes approximately 20
minutes to fully adhere to the surface.
4 Secure the telematics module to the mounting
bracket using the provided retaining fasteners.
Genie part number 1289520GT or
1289521GT or 1289522GT or 1289523GT.
1 retaining fasteners
2 telematics module
3 telematics bracket
5 Connect the telematics module to the retrofit
harness.
Genie part number 1292198GT.
Note: Harness connectors are keyed for proper
installation.
Component damage hazard.
Improper connections will result
in damage to the telematics
module and it is not covered
under warranty.
example of keyed harness connector
