Rev C
Instructions
GTH
™
Models
Part No. 1295251GT
Lift Connect
™
49
6 Route the harness out the back end of the
armrest console.
7 Secure the armrest to the console using the
fasteners set aside.
8 Install the PCB assembly access panel.
9 Using a mild cleaning solvent, clean the top of
the armrest mounting plate.
10 Remove and discard the protective film from
the adhesive tape located on the bottom of the
telematics bracket.
Genie part number 1289561GT.
11 Adhere the bracket to the top of the armrest
mounting plate.
Note: The bracket should be mounted 2 inches /
5 cm from the end of the mounting plate and
centered between the right and left sides.
Note: The adhesive takes approximately 20
minutes to fully adhere to the surface.
1 retaining fasteners
2 telematics module
3 telematics bracket
4 armrest mounting plate
12 Secure the telematics module to the mounting
bracket using the provided retaining fasteners.
Genie part number 1289520GT.
13 Connect the telematics module to the retrofit
harness.
14 Connect the black negative battery cable to
the engine battery.
15 Locate the machine serial label.
16 Using a mild cleaning solvent, clean an area
next to the serial label. Adhere one of the
provided ESN decals to the machine.
Note: The ESN decals are provided with the
telematics module.
17 Adhere the lexan cover decal over the ESN
decal.
Genie part number 1291624GT.
Register and activate the telematics
module. Refer to page 7.
