Rev C
Instructions
Procedure - S
®
and Z® Booms
Part No. 1295251GT
Lift Connect
™
25
2 Using a mild cleaning solvent, clean the back
of the ground control box.
1 telematics bracket
3 Remove and discard the protective film from
the adhesive tape located on the bottom of the
telematics bracket.
Genie part number 1289561GT.
4 Adhere the bracket to the back of the control
box.
Note: The adhesive takes approximately 20
minutes to fully adhere to the surface.
5 Secure the telematics module to the mounting
bracket using the provided retaining fasteners.
Genie part number 1289520GT or
1289521GT.
1 telematics bracket
2 telematics module
3 retaining fasteners
6 Connect the telematics module to the retrofit
harness.
Genie part number 1292198GT.
Note: Harness connectors are keyed for proper
installation.
Component damage hazard.
Improper connections will result
in damage to the telematics
module and it is not covered
under warranty.
7 example of keyed harness connector
8 Connect the loose end of the retrofit harness
to the 8 pin connector located on the left side
of the control box.
1 connector, 8 pin
