Instructions
Rev C
Light Towers - AL™, RL™ Models
62
Lift Connect
™
Part No. 1295251GT
4 Secure the telematics module to the mounting
bracket using the provided retaining fasteners.
Genie part number 1289520GT or
1289521GT or 1289522GT.
1 retaining fasteners
2 telematics module
3 telematics bracket
5 Connect the telematics module to the retrofit
harness.
Genie part number 1292198GT.
Note: Harness connectors are keyed for proper
installation.
Component damage hazard.
Improper connections will result
in damage to the telematics
module and it is not covered
under warranty.
example of keyed harness connector
6 Route the loose end of the retrofit harness into
the cabinet through the access hole.
1 telematics module
7 Open the ground control side of the cabinet
and locate the 8 pin connector in the harness
from the ground control box.
8 Connect the loose end of the retrofit harness
to the 8 pin connector.
9 Secure the harness to the existing cables
using the provided cable ties.
Genie part number 21121GT.
10 Close the cabinet.
11 Locate the machine serial label.
12 Using a mild cleaning solvent, clean an area
next to the serial label. Adhere one of the
provided ESN decals to the machine.
Note: The ESN decals are provided with the
telematics module.
13 Adhere the lexan cover decal over the ESN
decal.
Genie part number 1291624GT.
Register and activate the telematics
module. Refer to page 7.
